Nexicom Knowledge Base


Nexicom Knowledge Base

Support Centre

Find answers and help fast

How Can We Help?
< All Topics

Connection Setup for PPPoE (Tilgin HG2301)

If you are connecting to the Internet using a Nexicom DSL modem or a Motorola adapter, you will need a PPPoE setup.

If your Digital Telephone and Internet aren’t working and the Power light on your Tilgin is not lit green, perform a factory reset on the Tilgin and follow the procedure below.

Note: Before proceeding with this setup, ensure that your modem or Motorola adapter is connected to the WAN port on the Tilgin HG2301. Also ensure that one end of an ethernet cord is plugged into the AB, C, or D port on the Tilgin HG2301 and the other end plugged into your computer.


1. Open your internet browser.

Note: Internet Explorer was used for the purposes of this instructional document but any web browser will work (Mozilla Firefox, Google Chrome, Safari, etc.)


2. In the address bar, type and press Enter.

Note: If this does not work, hold the reset button on the Tilgin down until all of the lights light up green and try again. If this still does not work, please give our Internet Helpdesk a call at 1-888-639-4266.


3. Type admin in both the Username and Password boxes located at the top-right corner of the screen.

Click Login.


4. Click the Setup tab located at the top of the page.


5. Click the Connections option that appears in the left-menu bar under the WAN Setup heading.


6. Click to add a check mark in the box labeled Delete.

Click Apply.


7. Fill in the fields with the corresponding information:

  • Name – NexicomPPPOE
  • Type – PPPoE (PPP over Ethernet)
  • Description – Nexicom PPPOE

Click Add.


8. Under the General heading, click to add a check mark in the box labeled Enabled.


9. Under the PPP heading, type your Nexicom username in the box labeled Username and your Nexicom password in the box labeled Password.

Note: Your username must end with


10. Under the Firewall heading, click to add a check mark in the box labeled Clamp TCP MSS to path MTU.

Click the Apply button located at the bottom of the page.


11. Click the Management Server option that appears in the left-menu bar under the Provisioning heading.


12. Click to add a dot in the circle labeled Use URL.

Type in the box labeled URL.

Click the Apply and save settings button.

Note: The above URL is case sensitive and must be typed exactly as shown in order for it to work.


The Tilgin should now begin downloading an update from the management server. During this update, the WWW light should be green and the Power light should be flashing at a fast pace either red or green. When the update is complete, the Power, WWW, and Phone 1 light should all be on steady green indicating the service is ready to use.

Note: If you continue to have difficulties with the Phone or Internet service after following these steps, please call our Internet Helpdesk at 1-888-639-4266 for further assistance.